Filter
Top Products
Description of symbols
The rating plate on your tool may show symbols. These
represent important information about the product or
instructions on its use.
Wear hearing protection.
Wear eye protection.
Wear breathing protection.
Conforms to relevant standards for
electromagnetic compatibility.
Specifications
Nominal voltage: 230–240Vac ~ 50Hz
Input power: 250W
No load speed: 1400 RPM
Table size: 300mm x 300mm
Throat length: 200mm
Bevel angle: 0° to 45°
Cutting capacity: 80mm
Saw blade length: 1400mm
Saw blade width*: 3–12.7mm
Teeth per inch: 6 TPI
* Supplied with a 1400 x 0.35 x 6.35mm general purpose blade
Safety rules for laser lights
The laser light/laser radiation used in the GMC REDEYE®
system is Class 1 with maximum 0.39mW and 650nm
wavelengths. These lasers do not normally present an
optical hazard, although staring at the beam may cause
flash blindness.
Warning. Do not stare directly at the laser beam. A
hazard may exist if you deliberately stare into the beam,
please observe all safety rules as follows;
• The laser shall be used and maintained in accordance
with the manufacturer’s instructions.
3
Dear Customer
If you require any help with your product, whether it
is a Warranty claim, spare part or user information,
please phone our Help Line for an immediate response.
Phone 1300 880 001 in Australia or 0800 445 721 in
New Zealand.
Introduction
Your new GMC power tool will more than satisfy your
expectations. It has been manufactured under stringent
GMC Quality Standards to meet superior performance
criteria.
You will find your new tool easy and safe to operate,
and, with proper care, it will give you many years of
dependable service.
Caution. Carefully read through this entire Instruction
Manual before using your new GMC Power Tool. Take
special care to heed the Cautions and Warnings.
Your GMC power tool has many features that will make
your job faster and easier. Safety, performance, and
dependability have been given top priority in the
development of this tool, making it easy to maintain
and operate.
Environmental protection
Recycle unwanted materials instead of
disposing of them as waste. All tools, hoses
and packaging should be sorted, taken to
the local recycling centre and disposed of
in an environmentally safe way.