Filter
Top Products
11
Mitre table lock
The mitre table lock (25) is used
to lock the table at the desired
mitre angle (Fig. E).
The mitre saw cuts from 0° to
52° both left and right. To adjust
the mitre angle loosen the mitre
table lock and using the mitre
table handle adjust the mitre
angle to the desired position. The mitre table features
positive click stops at 0°, 15°, 22.5°, 30°, 45° and 50° for
quick setting of common mitre angles.
WARNING. Be sure to tighten the mitre table lock before
making a cut. Failure to do so could result in the table
moving during the cut and cause serious personal injury.
Bevel lock
The bevel lock (16) is used to
set the blade at the desired bevel
angle (Fig. F). The mitre saw
bevel cuts from 0° to 45° to the
left. To adjust the bevel angle
loosen the bevel lock and adjust
the saw arm to the desired
bevel angle.
WARNING. Be sure to tighten the bevel lock before making
a cut. Failure to do so could result in the saw arm moving
during the cut and cause serious personal injury.
Clamp assembly
The clamp assembly (10)
can be mounted to the fence,
either side of the saw blade, to
suit the task at hand (Fig. G).
When performing a bevel cut
the workpiece clamp should be
positioned on the right hand side
of the fence.
Use the clamp assembly lock
(11) at the back of the fence to
secure the clamp assembly in
position (Fig. H).
Spindle lock button
The spindle lock button (26)
prevents the blade in the saw
from rotating (Fig. I). Depress
and hold the spindle lock button
while installing, changing, or removing the blade.
Rotating lower
blade guard
The rotating lower blade guard
(12) provides protection from
both sides of the blade (Fig. J).
It retracts over the upper blade
guard (9) as the saw is lowered
into the workpiece.
Dust bag
The dust bag (15) fits over the
dust extraction port (27) (Fig. K).
For more efficient operation,
empty the dust bag when it is no
more than half full. This allows
better air flow through the bag.
E
F
G
H
IbIa
J
K
LSMS210A
LSMS250A