Filter
Top Products
3
Description of symbols
The rating plate on your tool may show symbols.
These represent important information about the
product or instructions on its use.
Wear hearing protection.
Wear eye protection.
Wear breathing protection.
Double insulated for additional protection.
Conforms to relevant standards for
electromagnetic compatibility.
Specifications LSMS210A LSMS250A
Nominal voltage: 230-240Vac ~ 50Hz 230-240Vac ~ 50Hz
Input power: 1600W 2400W
No load speed: 5000min
-1
5500min
-1
Blade size: Ø210mm x Ø16mm Ø250mm x Ø16mm
bore bore
Number of teeth: 24 24
Mitre angles: 0° to 52° left & right 0° to 52° left & right
Bevel angles: 0° to 45° left 0° to 45° left
Straight cut at 0° x 0°: 200mm x 60mm 295mm x 83mm
Mitre cut at 45° x 0°: 140mm x 60mm 205mm x 83mm
Bevel cut at 0° x 45°: 200mm x 34mm 295mm x 43mm
Compound mitre cut
at 45° x 45°: 140mm x 34mm 205mm x 43mm
Insulation class: Double insulated Double insulated
Laser class: II II
Laser wavelength: 400-700nm 400-700nm
Laser output power: ≤1mW ≤1mW
Introduction
Your new GMC power tool will more than satisfy
your expectations. It has been manufactured under
stringent GMC Quality Standards to meet superior
performance criteria.
You will find your new tool easy and safe to operate,
and, with proper care, it will give you many years
of dependable service.
CAUTION. Carefully read through this entire Instruction
Manual before using your new GMC Power Tool. Take
special care to heed the Cautions and Warnings.
Your GMC power tool has many features that will make
your job faster and easier. Safety, performance, and
dependability have been given top priority in the
development of this tool, making it easy to maintain
and operate.
Environmental protection
Recycle unwanted materials instead
of disposing of them as waste. All tools,
hoses and packaging should be sorted,
taken to the local recycling centre and
disposed of in an environmentally safe way
.
WARNING. It may be more difficult to see the laser line
in conditions of bright sunshine and on certain surfaces.