Filter
Top Products
16
11. Re-fit and re-set the riving knife and the saw blade guard.
12. Replace the table insert.
13. Before using the saw again, check that all safety
devices are in good working order.
IMPORTANT. After replacing the saw blade, make sure the
saw blade runs freely by turning the blade by hand.
14. Plug the machine into a mains socket and run the saw at
no load before using it to cut any materials.
Maintenance
WARNING. Always ensure that the tool is switched off and
the plug is removed from the power point before making
and adjustments or maintenance procedures.
Power cord maintenance
If the supply cord needs replacing, the task must be carried
out by the manufacturer, the manufacturer’s agent, or an
authorised service centre in order to avoid a safety hazard.
Cleaning
1. Keep the tool’s air vents unclogged and clean at all times.
2. Remove dust and dirt regularly. Cleaning is best done
with a soft brush or a rag.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
CAUTION. Do not use cleaning agents to clean the plastic
parts of the saw. A mild detergent on a damp cloth is
recommended.
General inspection
Regularly check that all the fixing screws are tight. They
may vibrate loose over time.