Graco 262612 Paint Sprayer User Manual


 
Unclogging Spray Tip/Guard Assembly
3A1698F 15
Unclogging Spray Tip/Guard
Assembly
1. To unclog tip obstruction, engage trigger lock and
put prime/pressure relief valve UP to release pres-
sure.
2. Reverse spray tip to UNCLOG position.
3. Aim sprayer at waste area, disengage trigger lock,
and put prime/pressure relief valve DOWN to spray
position. Pull trigger to clear clog.
4. Engage trigger lock. Put prime/pressure relief valve
UP to release pressure and rotate spray tip back to
SPRAY position.
5. Disengage trigger lock, put prime/pressure relief
valve DOWN to spray position, and resume spray-
ing.
6. If tip is still clogged, you may have to repeat steps
1 - 5 and rotate the tip from SPRAY to UNCLOG
several times. Repeat step 1 to release pressure,
remove and clean filter, or replace with new tip
assembly.
NOTE: Filter assembly is reverse-threaded:
Turn left (or counter-clockwise) to install.
Turn right (or clockwise) to remove.
7. When obstruction is cleared, engage trigger lock
and rotate arrow-shaped handle back to SPRAY
position.
Do not operate or spray near children. Do not aim the
sprayer at, or spray any person or animal. Keep hands
and other body parts away from the discharge. For
example, do not try to stop leaks with any part of the
body.
ti14994a
ti14999a
ti16699a
ti16700a
ti14991a
ti14991a
ti14995a
ti15425a
ti16698a
ti16701a
ti14994a
ti14999a
ti16700a
ti16992a
NOTICE
Make sure filter is completely screwed into the Tip/Guard
Assembly to avoid damage to the filter. Do not use a
damaged filter or poor sprayer performance may result.
ti14995a
ti15425a
ti16698a
ti16701a
ti14989a
ti14989a
ti14985a
ti14994a
ti16699a
ti16992a