Graco 262612 Paint Sprayer User Manual


 
Warnings
3A1698F 3
Warnings
The following warnings are for the setup, use, maintenance, and repair of this equipment. The exclamation point
symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these sym-
bols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard
symbols and warnings not covered in this section may appear throughout the body of this manual where applicable.
Grounding Wire Repair
If the grounding wire breaks at the spool end,
perform the following steps:
1. Unwind wire from grounding spool and use a flat
screwdriver to pry apart the grounding spool.
2. Loosen screw on terminal and remove broken wire.
Strip insulation from grounding wire, insert into ter-
minal and tighten screw.
3. Snap the grounding spool back together.
If the grounding wire breaks at the grounding plug,
perform the following steps:
1. Pull rubber boot off of wire at grounding plug and
slide boot over grounding wire.
2. Loosen screw and remove broken wire. Insert
stripped grounding wire and tighten screw.
3. Replace rubber boot onto grounding plug.
WARNING
FIRE AND EXPLOSION HAZARD (GROUNDING)
Some oil-based and flammable materials generate static electricity when sprayed. Static electricity creates
an explosion and fire risk. Your sprayer has a grounding cord that will conduct the static electricity to a
grounded electrical outlet. The sprayer and all objects in spray area shall be properly grounded to protect
against static discharge, sparks or shocks.
Connect the grounding cord when spraying flammable or static producing oil-based materials.
If there is static sparking or if you feel a shock, stop spraying immediately and connect the sprayer to a
properly grounded electrical outlet with the ground wire provided.
GROUNDING INSTRUCTIONS
Move the sprayer away
from the spray area to a
non-hazardous location.
Plug the ground wire
into the sprayer.
Unwind the ground wire from the spool
and plug it into a properly grounded
electrical outlet.
If the ground wire is not long enough to
reach a grounded electrical outlet, a
3-wire grounded extension cord may be
used to reach a grounded outlet.
ti17082a
ti17080a
ti17081a