Filter
Top Products
Shutdown and Cleaning
3A1698F 17
8. Disengage trigger lock, reverse tip to UNCLOG
position, and pull trigger for 5 seconds to prime
sprayer.
9. Put prime/pressure relief valve DOWN to spray
position. Trigger sprayer into waste area until no
paint appears in water or flushing fluid.
10. If sprayer is not completely clean, repeat steps 4-9.
11. Engage trigger lock and put prime/pressure relief
valve UP to release pressure.
12. Remove material cup and discard used fluid.
13. Use a stiff wire such as a paper clip to make sure
vent hole is open.
14. Remove Spray Tip/Guard Assembly and clean with
water or flushing fluid. A soft brush can be used to
loosen and remove dried material if needed.
To avoid serious injury or damage to equipment, do not
expose the sprayer electronics to flushing solvents.
Keep sprayer at least 10 in. above the rim of the con-
tainer when flushing.
Keep spray area well-ventilated. Keep a good supply
of fresh air moving through the area. When flushing
with solvents, always ground the sprayer and waste
container.
ti14995a
ti14991
ti16698a
ti14991a
ti15425a
ti15491a
ti16701a
ti16713a
ti15529a
ti16727a
NOTICE
The tip is permanently attached to the guard. Removing
the tip from the guard will result in damage to the tip
assembly.
Do not store tip/guard assembly or suction tube in sol-
vent other than mineral spirits. Damage to parts may
occur.
ti14994a
ti14999a
ti16699a
ti16700a
ti17102a
ti15003a
ti15003a