Filter
Top Products
Repair
38 309856P
Slip-Fit Polycarballoy Mix
Module
See page 48 for available Slip-Fit Polycarballoy Mix
Module sizes.
1. Follow Pressure Relief Procedure, page 18.
2. Flush Gun, page 22.
3. Remove fluid manifold (G). Leave air connected.
4. Remove air cap (9), retainer (28), and CeramTip
(40).
5. Remove mix module nut (25), using air cap (9)
backwards, or a wrench. Remove front seal (46).
TI3852a
G
TI3843a
4028
9
TI3843a
9
46
25
6. Disengage piston safety lock, page 12. Trigger and
detrigger gun once to release mix module (39)
from fluid housing (7). Remove mix module.
Engage piston safety lock.
If mix module (39) does not protrude from fluid
housing (7), slightly loosen then retighten lock
ring (11), to allow gripping of edge for removal.
7. Push mix module (39) onto rod (31) as far as pos-
sible.
39
7
TI3845a
39
7
TI3845a
31