Filter
Top Products
Setup
309915D 11
Wetting System
CAUTION CAUTION
1 Fill hopper (G) with prepared
texture material.
Do not mix material in hopper.
Mixing material in hopper can
damage hopper, result in an
inconsistent mix and packout can
occur.
2 Install tip. See Nozzle Selection
Chart, page page 16.
3 Open gun air valve (23) to
relieve air pressure.
Do not allow material to flow out of
gun when air valve (23) is closed or
material packout in needle can
occur.
NOTE: If spraying a simulated
acoustic and coarse aggregate
material, disconnect hose at gun,
prime pump and hose and circulate
material back into hopper for 10
seconds. Turn off pump. Install gun
and tip.
4 Inspect hose for kinks which
could restrict fluid flow.
5 Trigger gun into a pail. When
texture material appears at tip,
move gun to hopper and circu-
late until there is a solid stream
of texture material.
6 See System Adjustment, page
17 for proper spray pattern and
pump and gun adjustments.
7 On the sprayer, adjust gun air
pressure (U) and pump air
pressure (T) to achieve desired
results.
ti3905a
TI
TIA
U
T
ti3910a