Filter
Top Products
Warnings
309915D 3
WARNINGS
Burn Hazard
Equipment surfaces and fluid that is heated can become very hot during operation. To avoid severe
burns, do not touch hot fluid or equipment. Wait until equipment/fluid has cooled completely.
Pressurized Equipment Hazard
Compressed air can inject in skin. Air tubing rupture can cause injury if disconnected while under
pressure. To reduce risk of injury:
• Never exceed maximum working pressure of any attachment.
• Do not direct airstream at body.
• Follow Pressure Relief Procedure, page 6 whenever you are instructed to relieve pressure, stop
spraying, service equipment, install or clean spray nozzle or disconnect or connect hose.
Cleaning Solvent Hazard with Plastic Parts
Use only compatible water-based solvents to clean plastic structural or pressure-containing parts. Many
solvents can degrade plastic parts to the point where they could fail. Such failure could cause serious
injury or property damage. See Technical Data on page 21 of this instruction manual and in all other
equipment manuals. Read fluid and solvent manufacturer’s warnings.
Personal Protective Equipment
Wear appropriate protective equipment when operating, servicing or when in the operating area of this
equipment to help protect yourself from serious injury, including eye injury, inhalation of toxic fumes,
burns and hearing loss. This equipment includes, but is not limited to:
• protective eye wear
• clothing and respirator as recommended by fluid and solvent manufacturer
• hearing protection
•gloves
CAUTION
Water or material remaining in unit when temperatures are below freezing can damage pump and/or delay startup.
To insure water and material are completely drained out of unit:
1. Remove material line from sprayer.
2. Tip sprayer to allow material (water) to flow out of pump inlet.
Before adding material or starting unit in cold weather, run warm water through pump.