Filter
Top Products
Daily Start-Up
12 311320G
Daily Start-Up
1. Connect air supply to gun, page 9.
2. Adjust air cap valve, page 10.
3. Saturate felt in felt wiper with gun cleaner
using flush can.
4. Trigger gun multiple times to ensure valving
rod moves the full travel quickly and freely.
5. Open both manual valves, page 8.
6. Test spray on disposable surface and
adjust spray pattern as needed. (See Spray
Pattern Adjustment procedure, page 14.)
Daily Shutdown
1. Follow Pressure Relief Procedure, page
13.
2. Shut down proportioning unit as required.
Ensure gun is attached to coupling block and
air hose, and the proportioning unit is at
desired temperature and pressure.
CAUTION
Sluggish valving rod action may result in valving rod
sticking in open position when fluid pressure is
applied. Always have a 5/16 in. nut driver available to
quickly close manual valves on coupling block.
Do not exceed 1000 psi (7 MPa, 70 bar)
maximum fluid working pressure even in
static de-triggered conditions, or check
valve damage may result.
Follow when gun is out of service for any
length of time. Daily disassembly of gun for
cleaning is not recommended if it has been
operating properly. However, if you remove
the gun from the coupling block, flush and
clean thoroughly.