Filter
Top Products
Operation / 操作
14 313483A
Pressure Relief Procedure / 泄压步骤
Spray Gun (Top Coat Pump) / 喷枪（面漆泵）
English
1. Lock gun trigger
safety and turn
engine OFF.
2. Turn on/off switch
to OFF and turn
pressure control
knob fully coun-
terclockwise.
3. Unlock trigger
safety. Hold
metal part of gun
firmly to side of
grounded metal
pail and trigger
gun to relieve
pressure.
4. Lock gun trigger
safety. Open
pressure drain
valve. Leave
valve open until
ready to spray
again.
NOTE: If you sus-
pect that the spray
tip or hose is com-
pletely clogged, or
that pressure has
not been fully
relieved after follow-
ing the previous
steps, VERY
SLOWLY loosen the
tip guard retaining
nut or hose end cou-
pling to relieve pres-
sure gradually, then
loosen completely.
Then clear tip or
hose.
中文
1. 锁上喷枪扳机的
安全销，关闭发
动机。
2. 关断通 / 断开
关，并将压力控
制旋钮逆时针旋
到底。
3. 开启扳机的安全
销。将喷枪的金
属部分紧紧靠在
接地金属桶的侧
边，然后扣动喷
枪扳机以便释放
压力。
4. 锁上喷枪扳机的
安全销。打开泄
压阀。准备再次
喷涂之前让阀门
一直开着。
注释：如果怀疑喷嘴
或软管完全堵塞或在
完成前述步骤后怀疑
压力未完全释放掉，
应极为缓慢地松开喷
嘴护罩的固定螺母或
软管端部的接头，使
压力逐渐释放掉，然
后再完全
松开。然后清理喷嘴
或
软管。
ti13130a
ti10796b
ti6208b
ti13050a
ti13128a
ti13131a
ti13130a