Filter
Top Products
Setup
313869B 13
Setup
Connect Air Line
NOTE:
• If your regulated air source does not
have a filter, install an air filter (G) on
each air line to ensure a dry, clean air
supply to the gun. Dirt and moisture can
ruin the appearance of your finished
workpiece. See FIG. 5.
• You must install a separate air pressure
regulator (F) on the CYL, FAN, and
ATOM air lines to control air pressure to
the gun. See FIG. 6 and FIG. 7.
• Install a bleed type air shutoff valve (E)
on each gun air supply line, down-
stream of the gun air regulator, to shut
off air to the gun.
1. The gun cylinder, fan, and atomization air
must be supplied and regulated separately.
To regulate air remotely, use solenoids (see
FIG. 6 and FIG. 7).
NOTE: The three air inlet fittings accept 6 mm
OD tubing.
2. Connect each air hose (D) to a regulated
air supply line (H).
FIG. 5: Connect Air Line
ti01990a
H
G
FED