Filter
Top Products
G0508 10 HP Industrial Dust Collector
-11-
Inventory
After all the parts have been removed from the
two boxes, you should have the following items:
Contents (Figure
2–4) Qty
A. Main Housing with Motor ............................
1
B.
Inlet ............................................................. 1
C. Collectors ...................................................
4
D. Supporting Legs .........................................
4
E. Base ...........................................................
1
F. Hanger Supports ........................................
4
G. Hangers ......................................................
4
H. Upper Filter Bags (fabric) ...........................
4
I. Lower Collection Bags (plastic) ..................
4
J. Casters .......................................................
4
K. Rubber Gaskets .........................................
4
L. Bag Clamps ................................................
8
M. Hardware Bag (not shown) ......................... 1
— Combo Wrench 10/12mm ...................... 1
— Phillips Head Screw M6-1.0 x 10 ........... 1
— Flange Bolts
1
⁄4"-20 x
1
⁄2" ...................... 12
— Flange Bolts
5
⁄16"-18 x
1
⁄2" ..................... 32
— Flat Washers
5
⁄16" ................................. 64
— Hex Bolts
5
⁄16"-18 x 1" ........................... 32
— Hex Nuts
5
⁄16"-18 .................................. 32
Figure 2. Model G0508 Inventory (A–D).
In the event that any nonproprietary parts are
missing (e.g., a nut or a washer), we would be
glad to replace them, or for the sake of expedi
-
ency, replacements can be obtained at your local
hardware store.
NOTICE
Some hardware/fasteners listed in the inven-
tory may arrive pre-installed on the machine.
Check these locations before assuming that
any items from the inventory list are miss
-
ing.
A
B
C
D
E
F
G
H
I
Figure 3. Model G0508 Inventory (E–I).
J
K
L
Figure 4. Model G0508 Inventory (J–L).