Filter
Top Products
G0508 10 HP Industrial Dust Collector
-13-
5. Attach the supporting legs to the housing
bracket with
5
⁄16"-18 x
1
⁄2" flange bolts.
6. Position the base on top of the supporting
legs (see
Figure 8).
Figure 8. Base attached to supporting leg.
Flange Bolts
10. With assistance, position and hold the collec-
tor so the holes in the collector flange match
with those of the rubber gasket and main
housing.
11. Insert and hand tighten one
5
⁄16"-18 x 1"
flange bolt, two
5
⁄16" flat washers, and one
5
⁄16"-
18 hex nut in all eight holes.
12. Tighten the eight flange bolts and nuts in a
alternating fashion so that the rubber gasket
is evenly compressed without deformation.
13. Repeat Steps 10–13 for the remaining col-
lectors.
14. Place the inlet on the top center circular
flange of the main housing (see
Figure 10).
Figure 10. Inlet mounted on main housing.
Screw
7. Fasten the supporting legs to the base with
5
⁄16"-18 x
1
⁄2" flange bolts.
8. With assistance, turn the entire assembly
over so that the casters rest on the floor.
9. Position and hold the rubber gasket against
the square opening in the main housing
(see
Figure 9).
Figure 9. Collector mounted to main housing.
Mounting Bolts
Rubber Gasket
Collector
Main Housing
15. Rotate the inlet so the hole in the inlet aligns
with the hole in the housing flange.
16. Use the M6-1 x 10 Phillips head screw to fas-
ten the inlet securely to the housing flange.