Filter
Top Products
-14-
G0508 10 HP Industrial Dust Collector
17. Slide the hanger into the hanger support,
aligning the two holes on each part.
18. Secure this hanger assembly with two
1
⁄4"-20
x
1
⁄2" flange bolts (see Figure 11).
Figure 11. Hanger attached to hanger support.
Hanger
Hanger Support
19. Mount the hanger assembly on the protruding
rod on the collector as shown in
Figure 12.
Figure 12. Hanger assembly mounted onto
collector.
Hanger
Assembly
20. Align the hanger assembly so that the hook
at the top is directly over the center of the col
-
lector.
21. Secure the hanger assembly with one
1
⁄4"-20
x
1
⁄2" flange bolt (see Figure 12).
22. Repeat Steps 18–22 for the remaining hang-
er assemblies.
23. Place the loop at the top of the upper col-
lection bag over the top hook of the hanger
assembly (see
Figure 13).
Figure 13. Upper filter bag mounted on hanger
assembly.
Bag Loop
Hanger
Assembly
24. Thread the bag clamp into and around the
bottom seam of the upper collection bag (see
Figure 14).
Flange
Bolt