Filter
Top Products
-12-
Model G0517 Mill/Drill
To assemble the mill/drill:
1. Mount the stand to the floor in your desired
location.
2. Place the splash tray on top of the stand, as
shown in
Figure 8, and align the mounting
holes.
Note: Take care to install the splash tray in
the same orientation as shown in
Figure 8.
Installing the splash tray backwards will limit
column movem
ent.
Assembly
Before assembling your new mill/drill, deter-
mine if you will bolt your stand to the floor or
use machine mounts.
Machine mounts, shown
in Figure
5, give the advantage of fast leveling
and vibration reduction. For the Model G0517,
we recommend using four Grizzly Model G7159
machine mounts.
Figure 5. Machine mount example.
Bolting the machine to the floor is the strongest
option, but also the most permanent.
Lag shield anchors with lag bolts
(Figure 6) and
anchor studs (Figure
7) are two popular methods
for anchoring an object to a concrete floor.
Figure 6. Typical lag shield anchor and lag bolt.
Figure 7. Typical anchor stud.
Figure 8. Splash tray placed on the stand in the
correct orientation.
3. With the help of an assistant, place the base
assembly on top of the splash tray and align
the mounting holes.
4. Fasten the base assembly to the stand with
the mounting bolts, flat washers, and hex
nuts provided (see
Figure 9).
Front
Rear
Figure 9. Base assembly attached to stand.