Filter
Top Products
-16-
Model G0517 Mill/Drill
Installing/Removing
Morse Taper Sleeves
The Model G0517 includes an MT#1/#2 sleeve
and an MT#2/#3 sleeve. Always DISCONNECT
MACHINE FROM POWER when installing or
removing tooling.
To install a sleeve:
1. Make sure the spindle and sleeve tapers are
clean and free of any debris or grease.
2. Insert the sleeve into the spindle with the
tang side up (
Figure 19) and rotate with
upward pressure until it fits into place.
To remove a sleeve:
1. Lower the quill with the downfeed handle
and lock it in place with the quill lock (
Figure
21).
3. Using a rubber mallet or brass hammer (do
not use steel), tap the sleeve up into the
spindle to lock it in place (
Figure 20).
Figure 19. Installing a morse taper sleeve.
Figure 20. Tapping the sleeve into the spindle.
2. Insert the drift key into the quill slot as shown
in Figure 22.
Figure 21. Location of quill lock.
Quill Lock
3. Hold the sleeve with one hand and gently
tap the drift key with a hammer to knock the
sleeve out.
Figure 22. Drift key inserted in quill slot.
Drift Key