Filter
Top Products
-24-
Model G0517 Mill/Drill
SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person
-
al injury.
Protect the unpainted cast iron surfaces on the
table by removing vises and fixtures daily and
by wiping the table clean after every use—this
ensures moisture does not remain on bare metal
surfaces.
Keep tables rust-free with regular applications of
products like G96
®
Gun Treatment or Boeshield
®
T-9. See below for Grizzly model numbers:
Unpainted Cast Iron
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check
:
• Mill/drill is completely powered down at the
end of use.
• Excess cutting fluids and chips have been
removed and unpainted surfaces are dry and
protected.
• Loose mounting bolts.
• Mill/drill is clean and lubricated.
• Worn or damaged wires.
• Any other unsafe condition.
Monthly Check:
• Gibs are adjusted properly.
Schedule
Ways
Place two to three drops of ISO 68 or SAE 20W
non-detergent oil or similar lubricant directly
on the ways of the cross feed and longitudinal
table.
Lubrication
Figure 44. Cross feed and longitudinal ways.
Rack & Pinion
Brush a small amount of multi-purpose grease on
the column rack near the pinion. Move the column
up and down to distribute the grease.
Figure 45. Rack & pinion greasing location.
G2871—Boeshiel
d
®
T-9 12 oz Spray
G2870—Boeshiel
d
®
T-9 4 oz Spray
H3788—G96
®
Gun Treatment 12 oz Spray
H3789—G96
®
Gun Treatment 4.5 oz Spray
(ON BOTH SIDES)