Filter
Top Products
-20- G0518 Drum / Flap Sander
Figure 19. Power switch.
Starting the machine:
1. Wear safety glasses at all times when
running the sander!
2. Plug the sander into the power source.
3. Push the ON button shown in Figure 19.
Make sure that your finger is poised on the
OFF button, just in case there is a problem.
The sander should run smoothly, with little or
no vibration or rubbing noises. Strange or
unnatural noises should be investigated and
corrected before operating the machine fur-
ther.
If the sander seems to be running correctly, let it
run for a short time to ensure that the moving
parts are working properly with no excessive
vibration. If any problem develops, correct it
before attempting to use the machine.
If you cannot locate the source of unusual nois-
es, feel free to contact our service department for
help.
Before starting the machine:
1. Read this manual and make sure you under-
stand Section 1: Safety beginning on Page
2.
2. Make sure the acrylic eye shields are
installed (Figure 10) and are covering the
sanding drum and the flap sander.
3. Make sure all tools and foreign objects have
been removed from the machine.
4. Review Section 3: Circuit Requirements
beginning on Page 6, and make any neces-
sary changes.
Start Up
Loose hair and clothing
could get caught in
machinery and cause
serious personal injury.
Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Projectiles from the
machine could cause
serious eye injury.
Wear safety glasses at
all times.
Serious personal injury could result if the
machine is connected to the power source
during assembly or adjustment. Wait until
the machine is turned off, unplugged and all
working parts have come to a complete stop
before you attempt to assemble or adjust the
machine!