Filter
Top Products
G0529 Oscillating Spindle & Disc Sander -13-
Installing SpindleMounting Sander
To install the spindle onto the sander:
1. Disconnect the machine from the power
supply.
2. Select the proper diameter of spindle sleeve.
The Model G5029 comes with the following
four sizes of spindle sleeves:
•
1
⁄4"
•
5
⁄8"
• 1
1
⁄2"
•2"
3. Make sure the tapered end of the spindle
sleeve is clean before installing it into the
sander spindle.
4. Use the supplied open end wrenches to
secure the spindle as shown in Figure 6.
Note—Do not over tighten the spindle
sleeve, it could make removal difficult.
Figure 6. Installing spindle.
!
Figure 5. Cabinet hole location.
When the cabinet has been completed, it is time
to place the sander unit on top of the cabinet
stand.
To mount the sander to the top of the cabinet
stand:
1. With the help of an assistant, place the
sander on the cabinet stand.
The Model G0529
weighs 143 lbs.
Personal injury could
occur if the machine is
moved without addition-
al assistance. Seek help
when moving or lifting
the machine.
2. Align the holes on the rim of the cabinet
sides with the threaded holes in the rim of the
sander.
3. Secure the cabinet and the sander together
with the
5
⁄16"-18 x 1
1
⁄4" hex bolts,
5
⁄16" lock
washers, and
5
⁄16" flat washers combination
as shown in Figure 5.
!