Filter
Top Products
-16-
G0529 Oscillating Spindle & Disc Sander
The table must be aligned to the face of the sand-
ing disc so that the sandpaper does not rub
against the table.
To align the table:
1. Loosen the bolts that secure the table to the
table support bracket as shown in Figure 13.
2. Align the table so that there is a
1
⁄16'' gap
between the 12" disc and the table.
3. Tighten the bolts loosened in step 1.
4. Spin the disc by hand to check if the sand-
paper is touching the table. Note—DO NOT
turn the disc sander on at this point.
5. Repeat steps 1-3 if the sandpaper touches
table at any point in the rotation.
Aligning Table
Figure 13. Loosening table bolts.
Figure 12. Installing sanding disc.
Sanding Disc
Installation
The disc sander requires 12" sanding discs with
hook and loop backing.
To install a new sanding disc on the 12" disc
sanding surface:
1. Disconnect the machine from the power sup-
ply.
2. Remove the disc sanding table.
3. Remove the old sanding disc.
4. Install the new sanding disc as shown in
Figure 12.
!
!