Filter
Top Products
-14-
G0529 Oscillating Spindle & Disc Sander
To square the sanding tables:
1. Disconnect the machine from the power sup-
ply.
2. Set the table at 90˚ as shown in Figure 8.
3. Place a machinist square on the table and
against the sanding spindle to verify the table
is 90˚ from the edge of the sanding sleeve as
shown in Figure 9.
4. Adjust the pointer to 90˚.
Figure 8. Setting the table scale at 90˚.
Figure 9. Squaring the table and spindle.
Figure 7. Installing table inserts.
Squaring TableTable Inserts
The table inserts minimize the gap between the
working surface edge and the spindle. It is impor-
tant to use the proper table insert according to the
diameter spindle you are using.
The Model G5029 comes with the following four
table inserts:
• 2"
• 1"
• 2" elliptical
• 1" elliptical
Select the table insert that comes closest the
spindle sleeve diameter without touching it. The
elliptical inserts are used when sanding with the
table tilted.
Place the table insert into the table hole as shown
in Figure 7.
!
!
!
Pointer