Filter
Top Products
G0605X/G0606X Extreme Series 12" Table Saw
-19-
Extension Table
2. Fasten the rear rail to the table with five cap
screws and lock washers as shown in
Figure
13.
3. Thread two M10-1.5 x 25 hex bolts with flat
washers onto the right side of the table saw
cabinet as shown in
Figure 14. Do not fully
tighten the bolts.
Figure 14. Hex bolts installed.
4. Place the extension table between the rails
and slide the table slots over the bolts
installed in Step 3
.
Figure 13. Rear rail installed.
Components and Hardware Needed: Qty
Table Saw Unit ..................................................
1
Front Rail ...........................................................
1
Rear Rail ...........................................................
1
F ront (Main) Extension Table ............................
1
Lower Shelf ........................................................
1
Shelf End Plate ..................................................
1
Support Legs .....................................................
2
Lower Shelf Brackets ........................................
2
Cap Screws M8-1.25 x 25 ................................
8
Flat Head Screws M8-1.25 x 25 .......................
8
Flat Washers 8mm ........................................... 6
Hex Nuts M8-1.25 ............................................
6
Lock Washers 8mm .........................................
8
Hex Bolts M6-1 x 12 .........................................
4
Hex Bolts M10-1.5 x
25 .................................... 2
Feet
3
⁄8-16 x 2 ................................................... 2
Phillip Head Screws M6-1 x 12 ......................
12
Hex Nuts M6-1 .................................................
2
Hex Nuts
3
⁄8-16 ................................................. 2
Flat Washers 6mm .........................................
16
Flat Washers 10mm ..........................................
2
Figure 12. Front rail installed.
To install the front and rear rails:
1. Fasten the front rail (larger of the two) onto
the table saw with five flat head screws as
shown in
Figure 12.
Hex Bolts