Filter
Top Products
-50-
G0605X/G0606X Extreme Series 12" Table Saw
Figure 77. 45° stop bolt and jam nut.
45° Stop Bolt
Jam Nut
5. Continue adjusting the stop bolt until it con-
tacts the cabinet when the blade is at 45
°.
6. Tighten the jam nut.
To adjust the tilt indicator arrow:
1. Set the 90° stop bolt (see instructions on
Page 49).
2. Loosen the blade height handwheel set screw
and remove the handwheel.
3. Loosen the button head cap screw shown in
Figure 78 and move the tip of the indicator to
0°.
Figure 78. Tilt indicator arrow.
Indicator
Button Head
Cap Screw
Digital Readout
The digital readout displays the current blade
angle. We recommend you set the readout after
verifying the 90° and 45° blade tilt stops.
To set the digital readout
:
1. Move the blade angle to 0° and press the 0°
SET button (
Figure 79) for several seconds
until the readout displays 0.00.
2. Move the blade angle to 45° and press the
SET button for several seconds until the
readout displays 45.0.
Note: If you move the blade angle handwheel
when the power is
disconnected, the digital
readout will be incorrect when the saw is
reconnected.
Figure 79. Digital readout.
45° Set Button
0° Set Button
4. Loosen the jam nut (Figure 77) on the 45°
stop bolt, adjust the stop bolt up or down,
then check to see if the blade is 45° to the
table.
4. Tighten the cap screw and reinstall the
handwheel.