Filter
Top Products
-12-
G0613/14 Swivel Mast Metal Cutting Bandsaw
SECTION 2: CIRCUIT REQUIREMENTS
110/220V Single-
Phase (G0613)
Amperage Draw
The Model G0613 features a 110/220V motor
that is prewired for 110V and draws the following
amps under maximum load:
Motor Draw at 220V .............................7.7 Amps
Motor Draw at 110V ........................... 15.4 Amps
Circuit Requirements
We recommend connecting your machine to a
dedicated and grounded circuit that is rated for
the amperage given below. Never replace a circuit
breaker on an existing circuit with one of higher
amperage without consulting a qualified electri
-
cian to ensure compliance with wiring codes
. If
you are unsure about the wiring codes in your
area or you plan to connect your machine to a
shared circuit, consult a qualified electrician.
110V Circuit ...........................................
20 Amps
220V Circuit ...........................................
15 Amps
220V Connection
Rewire the motors according to the wiring con-
nection diagram on the inside cover of the motor
and pump junction boxes. Refer to G0613 Single
Phase 220V Wiring Diagram on Page 46 for
general wiring details. Also use the following
220V plug for your machine on a dedicated circuit
(see Figure
4):
220V Plug & Receptacle ..............................6-15
Extension Cords
Using extension cords may reduce the life of the
motor. Instead, place the machine near a power
source. If you must use an extension cord:
• For 110V, use at least a 12 gauge cord that
does not exceed 50 feet in length.
• For 220V, use at least a 14 gauge cord that
does not exceed 50 feet in length.
• Ensure that the extension cord contains a
ground wire and plug pin.
The Model G0613 is prewired for 110V opera
-
tion. If you plan to use your machine at
220V, you must rewire the motor. Refer to
the wiring diagram and consult a qualified
electrician.
Electrocution or fire could
result if this machine is
not grounded correctly or
if your electrical configu
-
ration does not comply
with local and state codes.
Ensure compliance by
checking with a qualified
electrician!
Figure 4. Recommended 220V 6-15
outlet and plug
.