Filter
Top Products
G0613/14 Swivel Mast Metal Cutting Bandsaw
-21-
Workstop
Your bandsaw has an adjustable workstop (Figure
14) that is easy to install and to use.
To install the workstop:
1. Thread the workstop rod in the base and
tighten the jam nut.
2. Slide the workstop onto the rod.
The vise
has a quick tighten/release lever and,
depending on the cut angle or workpiece shape,
you can remove or install the aluminium vise
clamp plate
(Figure 16) for additional holding
force.
Vise
Figure 16. Vise options and controls.
To use the vise:
1. Raise the bow and lock it in place by closing
the feed ON/OFF valve
(Figure 15).
Vise Lock Lever
Handwheel
Aluminum Plate
Figure 14. Workstop assembly.
3. Measure the distance from the blade to the
workstop, slide workstop to the needed posi
-
tion and tighten the lock lever.
Workstop Rod
Workstop
Lock
Lever
Jam Nut
Figure 15. Feed ON/OFF Valve.
Feed ON/OFF
2. Insert the workpiece between the jaws.
3. Use the handwheel
(Figure 16) to move the
jaws so they are within 1/8" from clamping
the workpiece
.
4. Use the vise lock lever to hold the workpiece
and quickly release the jaws to move the
workpiece after a cut.