Filter
Top Products
G0621 Wood/Metal Bandsaw
-11-
After all parts have been removed from the two
boxes, you should have the following items:
Main Components: (Figure
2) Qty
A. Bandsaw Unit ............................................. 1
B. 6" Handwheel ............................................. 1
C. Handwheel Handle ..................................... 1
D. Miter Gauge ................................................ 1
E. Table .......................................................... 1
F. Scale .......................................................... 1
G. Table Insert ................................................ 1
H. Stand Door Knob
5
⁄16"-18 x 1" ..................... 1
I. Dust Port 2
1
⁄2" ............................................. 1
J. Table Trunnion Knobs
3
⁄8"-16 ..................... 2
K. Rear Rail .................................................... 1
L. Front Rail .................................................... 1
M. Front Rail L-Brackets ................................. 2
N. L-Bracket Knobs
5
⁄16"-18 x
5
⁄8" ..................... 2
O. Fence Assembly ......................................... 1
P. Stand Assembly ......................................... 1
Fasteners and Tools: (not shown) Qty
• Rubber Feet (Stand) ..................................
4
• Hex Bolts
5
⁄16"-18 x 1" (Feet) ...................... 4
• Flat Washers
5
⁄16" (Feet) ............................. 4
• Hex Nuts
5
⁄16"-18 (Feet) .............................. 4
• Hex Bolts
5
⁄16"-18 x 3" (Stand/Bandsaw) .... 4
• Flat Washers
5
⁄16" (Stand/Bandsaw) ........... 8
• Hex Nuts
5
⁄16"-18 (Stand/Bandsaw) ............ 4
• Hex Bolt
3
⁄8"-16 x 3
1
⁄2" (Positive Stop) ........ 1
• Hex Nut
3
⁄8"-16 (Positive Stop) ................... 1
• Cap Screws M6-1 x 16 (Front Rail) ...........
2
• Front Rail T-Slot Nuts (Front Rail) .............
2
• Cap Screws M6-1 x 16 (Rear Rail) ............
2
• Guide Blocks (Blade Guides) .....................
4
• Thumbscrews
1
⁄4"-20 x
1
⁄2" (Blade Guides) . 4
• Phlp Hd Screws 10-24 x
1
⁄4" (Dust Port) ..... 4
• Hex Wrenches 3, 5, 8mm ................. 1 each
• Flat Wrench 12/14mm ................................
1
If any nonproprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them, or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed on the machine.
Check these locations before assuming that
any items from the inventory list are miss
-
ing.
Inventory
A
B
C
D
E
F
J
I
P
Figure 2. Main components inventory.
K
G
H
M
L
N
O