Filter
Top Products
-22-
Model G0632 (Mfg. 4/12+)
Adjusting Headstock
The Model G0632 headstock can be positioned
anywhere along the lathe bed and swiveled 360°.
To position the headstock along the length of
the lathe bed:
1. DISCONNECT THE LATHE FROM THE
POWER SOURCE!
2. Loosen the headstock lock handle (see
Figure 20).
Figure 20. Headstock lock handle.
3. Slide the headstock to the desired location on
the bed and use the headstock lock handle to
secure the headstock in position.
Note: The large clamping hex nut under-
neath the headstock will require occasional
adjusting to ensure proper clamping pressure
of the headstock to the bed. Turn this hex nut
in small increments to fine tune the clamping
pressure as needed.
8. Verifies the spindle direction switch is in the
center neutral position and the spindle speed
dial is turned all the way counterclockwise
so the spindle does not start turning at high
speed.
9. Ties back loose hair and clothing, and puts
on face shield and respirator. Takes all other
required safety precautions.
10. Starts the lathe and dust collector, adjusts the
spindle direction and lathe speed, and care-
fully begins the turning operation, keeping the
chisel against the tool rest the entire time it is
cutting.
Basic Controls
Refer to Figure 19 and the list below to familiarize
yourself with the lathe controls.
A. Front Belt Access Panel: Remove to access
the drive belt for changing speed ranges.
B. Spindle RPM Readout: Indicates the spindle
speed in RPM (rotations per minute).
C. Emergency STOP Button: Stops motor
when pushed in. Prevents restarting until it is
reset. Reset switch by rotating clockwise until
it pops out.
D. Spindle Direction Switch: Toggles the spin-
dle direction between clockwise (FWD) or
counterclockwise (REW).
E. Variable Speed Dial: Adjusts the spindle
speed from low to high within the range gov-
erned by the pulley belt position.
Figure 19. Control panel and RPM Readout.
A
B
C
D
E