Filter
Top Products
Model G0632 (Mfg. 4/12+)
-31-
Selecting Turning
To ol s
Lathe tools come in a variety of shapes and sizes,
and usually fall into five major categories.
• Gouges—Mainly used for rough cutting,
detail cutting, and cove profiles. The rough
gouge is a hollow, double-ground tool with
a round nose, and the detail gouge is a hol-
low, double-ground tool with either a round or
pointed nose.
Figure 38. Example of a gouge.
• Skew Chisel—A very versatile tool that can
be used for planing, squaring, V-cutting,
beading, and parting off. The skew chisel is
flat, double-ground with one side higher than
the other (usually at an angle of 20°–40°).
Figure 39. Example of a skew chisel.
• Scrapers—Typically used where access for
other tools is limited, such as hollowing oper-
ations. This is a flat, double-ground tool that
comes in a variety of profiles (round nose,
spear point, square nose, etc.) to match
many different contours.
Figure 40. Example of a round nose scraper.
• Parting Tools—Used for sizing and cut-
ting off work. This is a flat tool with a sharp
pointed nose that may be single- or double-
ground.
Figure 41. Example of a parting tool.
• Specialty Tools—These are the unique,
special function tools to aid in hollowing, bowl
making, cutting profiles, etc.