Filter
Top Products
Model G0756 (Mfg. Since 2/13)
-23-
1. DISCONNECT MACHINE FROM POWER!
2. Lower the spindle with the coarse downfeed
handle until you can press in the automatic
drift knob (see Figure 16).
Leaving the automatic drift knob pressed in
can result in the arbor coming free the next
time it is inserted into the spindle sleeve.
An improperly installed arbor can become
a projectile and result in serious injury to
operator or others nearby. Always verify
arbor is correctly installed before beginning
drilling operations.
3. While holding onto the tooling, raise the
spindle to the original position. It should auto-
matically release from the spindle.
4. Pull the automatic drift knob back to the out-
ward position.
1. DISCONNECT MACHINE FROM POWER!
2. Clean tooling and spindle tapers to ensure
proper seating.
3. Insert the MT#4 tooling into the spindle, and
maneuver the tang until it engages with the
slot at the end of the spindle.
4. Use a rubber or wooden mallet to seat the
tooling into the spindle by firmly tapping from
the bottom.
Note: If installing a drill chuck, make sure to
retract the jaws to prevent damage to chuck.
1. DISCONNECT MACHINE FROM POWER!
2. Lower the quill and rotate the spindle by hand
until the drift key holes in the spindle and quill
are aligned (see Figure 17).
Figure 16. Automatic drift knob.
Automatic Drift
3. Insert the drift key into the aligned holes and
allow the quill to rise, trapping the drift key.
4. Softly tap the end of the key while holding the
arbor/chuck assembly until it separates from
the spindle (see Figure 18).
Figure 17. Spindle and quill drift key holes
aligned.
Figure 18. Using drift key to remove arbor.
Installing Tapered Tooling
Removing Tooling with Automatic
Drift
Removing Tooling Manually