Filter
Top Products
G1022 Series Contractor Saws
-17-
SECTION 4: ASSEMBLY
Beginning Assembly
Stand Assembly
Most of your Model G1022 Series has been
assembled at the factory, but some parts must be
assembled or installed after delivery. We have
organized the assembly process into steps.
Please follow along in the order presented here.
TOOLS REQUIRED: High quality square and
straightedge, metric Allen
®
wrench set, flat screw-
driver, Phillips
®
screwdriver, dead blow hammer
and a 6" or 8" adjustable wrench.
Disconnect power to the
machine when perform-
ing any maintenance,
assembly or adjust-
ments. Failure to do this
may result in serious
personal injury.
!
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Some metal parts may
have sharp edges on
them after they are
formed. Please examine
the edges of all metal
parts before handling
them. Failure to do so
could result in injury.
Figure 7. Installing the rubber feet.
The Model G1022 Series is supplied with a
heavy-duty stand. To assemble the stand:
1. Fasten the plastic feet to all four legs using
the M10-1.5 x 25 hex bolts, 10MM flat wash-
ers and M10-1.5 hex nuts as shown in
Figure 7.
2. Locate the long upper and lower side braces
(2 each) and bolt to the legs using the M8-
1.25 x 16 carriage bolts, 8MM flat washers
and M8-1.25 hex nuts as shown in Figure 8.
Do not tighten any stand bolts at this time.
Figure 8. Assembled side panel.