Filter
Top Products
G1022 Series Contractor Saws -25-
7. If the blade guard/splitter is to the right of the
blade as shown in Figure 29. simply add
washers between the splitter and front
mounting bracket, and adjust the rear splitter
support as shown in Figure 29.
Figure 29. Improper splitter/blade alignment.
Figure 30. Proper splitter/blade alignment.
8. Recheck guard alignment to the blade and to
the table top. Adjust as necessary and tight-
en all the bolts before use. If the blade guard
is properly aligned, please skip ahead to the
next section; otherwise, continue with the
next step.
9. If the splitter is positioned to the left of the
blade, alignment cannot be achieved by
washer placement. Adjustment of the front
support bracket is required as shown in
Figure 30. Loosen the adjustment screws
and move to the right.
10. Recheck guard alignment to the blade and to
the table top. Adjust as necessary and tight-
en down all the bolts before use.
11. Adjust the blade to 45° and raise and lower it
through the full range. Readjust blade to 90°
and raise and lower it through the full range.
There should be no contact between the
base and the table insert or any other part of
the saw. If there is, repeat Steps 1-10.
Figure 28. Checking alignment of blade guard.