Filter
Top Products
G1060 22'' Scroll Saw -9-
Changing Blades
SECTION 5: ADJUSTMENTS
1. Remove Safety Shield assembly.
2. Remove Table Insert and flip open Chuck
Guards. Figure 3.
3. Mount Blade in Chucks. This can be done
with the help of the Chuck Holder, located on
the right edge of the table. Figure 4.
4. Mount Chucks between Upper and Lower
Arms (Blade teeth should be pointing down
toward the table) and close Chuck Guard.
Don’t replace the Safety Shield or Table
Insert just yet - wait until after you’ve adjust-
ed blade tension.
Figure 3.
Figure 4.