Filter
Top Products
G1060 22'' Scroll Saw -7-
Clean up
The working table for the G1060 is coated with a
waxy oil that protects them from corrosion during
shipment. Remove the protective coating with
mineral spirits and paper towels. Do not use
gasoline or other petroleum based solvents
because of their extremely low flash points. Do
not use chlorine-based solvents – if you happen
to splash some onto a painted surface, you’ll ruin
the finish.
WARNING!
Follow the safety rules listed below when
working with solvents:
1. Read and follow all directions and warnings
on the solvent label.
2. Work only in a well ventilated area.
3. Do not work near any type of open flame
(e.g., pilot lights, kerosene heaters, and so
on).
4. DO NOT smoke while working with flamma-
ble material.
5. Paper towels from the cleaning process are
extremely combustible. Dispose of waste
towels so they do not create a fire hazard.
Site Considerations
1. Working Clearances: Consider existing and
anticipated needs, size of material to be
processed through the machine, and space
for auxiliary stands, work tables or other
machinery when establishing a location for
your scroll saw.
2. Lighting and Outlets: Lighting should be
bright enough to eliminate shadow and pre-
vent eye strain. Electrical circuits should be
dedicated or large enough to handle amper-
age requirements. Outlets should be located
near each machine so power or extension
cords are clear of high-traffic areas. Observe
local electrical codes for proper installation
of new lighting, outlets, or circuits.