Filter
Top Products
-10- G1060 22'' Scroll Saw
Blade Tension
1. Turn the Blade Tension Adjustment Knob
clockwise to tighten, counterclockwise to
loosen. Figure 5. Proper tension is difficult to
quantify, but as you turn the knob clockwise,
you will notice when the blade initially begins
to tighten. The moment you feel the blade
tighten, give the knob about another
1
⁄4
turn
and then stop. Getting the blade any tighter
than this could snap it or cause unnecessary
strain on the chucks.
2. Once you have achieved proper blade ten-
sion, replace the table insert and safety
shield assembly.
Figure 5.
Table Tilt
Your Scroll Saw can handle any sort of bevel cut
between 0 and 30˚. Before you try this, however,
make sure the blade is perpendicular to the table.
Recalibration of this setting is easy.
1. Find a small block of wood that is known to
be square.
2. Loosen Tilt Adjustment Knob located direct-
ly under the table.
3. Place block against Blade. If there is any
space between the block and the blade, the
table is not at 90˚. Adjust the table to close
this space. Figure 6.
Figure 6.