Filter
Top Products
-10- G1067Z Wood Lathe
Tool Rest
Figure 7.
The tool rest is equipped with a cam-action
clamping system to secure it to the lathe bed.
When the lever is thrown, a locking plate lifts up
and secures the tool rest to the bed. To install the
tool rest assembly:
1. Remove the large Hex Nut and lock plate
from the bottom of the tool rest assembly.
2. Set the tool rest assembly on the lathe bed
with the clamp stud between the bed slot.
3. Set the tool rest lock handle so it is pointing
down. Re-install the lock plate and thread
the Hex Nut back onto the stud until it bot-
toms out.
4. Lift the lock handle approximately 90˚ and
tighten the Hex Nut
1
⁄2 to
2
⁄3 of a turn more.
5. Turn the tool rest lock handle until it locks the
tool rest down onto the bed. You may need
to adjust the Hex Nut in small increments to
fine tune how the tool rest assembly locks
down onto the bed.
Tailstock
Figure 8.
Thread the handle onto the tailstock handwheel
and tighten down the jamnut. Figure 8.