Filter
Top Products
-12- G1067Z Wood Lathe
SECTION 3: ADJUSTMENTS
The Model G1067Z headstock can be swiveled
180˚ as well as positioned anywhere along the
bed.
To position the headstock along the bed:
1. Loosen the quick release lever by pushing it
down. Figure 12.
2. Move the headstock to the desired position
and re-engage the quick release lever.
Figure 13. Note: The large Hex Nut under
the headstock will require occasional adjust-
ing to assure proper clamping pressure to
the bed. Turn the Hex Nut in small incre-
ments to fine tune the clamping pressure.
To swivel the headstock:
1. Loosen the quick release lever by pushing it
down.
2. Pull the spring loaded quick release set pin
(Figure 14) and rotate the headstock clock-
wise 90˚ or 180˚.
Headstock
Figure 12.
Figure 13.
Figure 14.
Quick release lever
Set pin