Filter
Top Products
G1148 15" Bandsaw -23-
SECTION 7: MAINTENANCE
V-Belts
To ensure optimum power transmission from the
motor to the blade, the V-belt must be in good
condition and operate under proper tension. Belts
should be checked for cracks, fraying and wear.
Belt tension should be checked at least every 3
months; more often if the bandsaw is used daily.
The V-belt is accessed via the bottom cover #25:
1. Squeeze the center of each V-belt.
2. Note the amount of deflection. Deflection
should be approximately
3
⁄4".
The table and other non-painted surfaces on the
Model G1258 should be protected against rust
and pitting. Wiping the saw clean after every use
ensures that moisture from wood dust isn’t
allowed to trap moisture against bare metal sur-
faces.
Some woodworkers recommend using automo-
tive paste wax on exposed steel and cast iron sur-
faces. The wax provides a layer of protection, as
well as reducing friction between lumber and the
table, making cuts faster and smoother. Avoid
waxes that contain silicone or other synthetic
ingredients. These materials can find their way
into lumber that’s being worked, and can make
staining and finishing difficult. If you use paste
wax, make sure that it’s 100% Carnauba wax.
NOTICE
Do not use paraffin or similar waxes on your
saw’s table. They can leave residues which
will make cutting more difficult over time.
Do not use silicon based lubricants. They
can rub off onto the wood and prevent it
from taking stains and finishes properly.
Ta b l e
Make your workshop “child-safe.” Remove
all safety keys from this and other machin-
ery when they’re not in use. Place sharp
tools and blades high enough to discourage
curious fingers. Store lubricants, finishes
and other harmful chemicals where they
can’t be easily reached. Lock your work-
shop securely when you are away.
Operating this equipment has the potential
to propel debris into the air which can cause
eye injury. Always wear safety glasses or
goggles when operating equipment.
Everyday glasses or reading glasses only
have impact resistant lenses, they are not
safety glasses. Be certain the safety glasses
you wear meet the appropriate standards of
the American National Standards Institute
(ANSI).