Filter
Top Products
-10- G3105 Combination Sander
Outside Belt Guard
Using two of the knobs provided, mount the out-
side belt guard to the cast-iron, inner belt guard.
See Figure 3.
Figure 3. Outside belt guard attachment points.
Guard
Mounting
Holes
Belt Table
Use the
3
/
8" - 16 x
3
/
4" cap screw and
3
/
8" washer
to secure the table to the inner belt guard. The
slotted bracket is provided to enable maximum
adjustment. See Figure 4. Use a machinist’s
square to set the table to 90˚ to the face of the
sanding belt. The table can also be tilted down an
additional 45˚. Simply loosen the cap screw and
adjust to the desired angle.
Figure 4. Belt table properly mounted.
Belt Table
Adj Cap Screw
DO NOT attempt to turn on the machine
during any step of the assembly process,
unless instructed otherwise. Make sure the
power switch is in the OFF position and the
plug is disconnected from its power source
during assembly. Failure to do so could
result in injury or electrical shock.