Filter
Top Products
G3105 Combination Sander
-11-
Disc Table Bracket
The disc table bracket mounts to the left side of
the sanding unit, below the disc. Use the two hex
bolts and washers provided. Tighten securely.
See Figure 5.
Figure 5. Disc table bracket in place.
Disc Table
1. Unscrew the table trunnion guide screws
from the disc table bracket.
2. Mount the disc table to the bracket with two
of the knobs and washers provided.
3. Reinstall the table trunnion guide screws
into the disc table bracket so that they fit
into the slots in the table trunnions.
4. Loosen the knobs to adjust the angle of the
table. Figure 6 shows the disc table at an
angle.
The edge of the disc table should be approxi-
mately
1
/
16" from the edge of the sanding disc.
Please note the distance from the edge of the
table to the sanding disc each time you change
the table angle. If any discrepancy is seen, sim-
ply pull the table slightly so that it is lined up prop-
erly.
Figure 6. Sanding disc table in place.