Grizzly G4186Z Saw User Manual


 
The tapered table pin should always be in
position when operating the bandsaw.
Operating without the pin can allow a step in
the table top which can catch your work-
piece during cutting. Serious personal
injury may occur if this caution is ignored.
Figure 3. Trunnion support in correct position.
G4186Z 18" Bandsaw -11-
Figure 4. Installing blade guide assemblies.
3. Before you place the table on the trunnion
support, install the blade guides and
thumbscrews that hold them in place. See
Figure 4.
4. Remove the tapered pin from the slot in the
table edge.
5. Move the table past the blade through the
table slot, rotate the table 90°, and set the
table trunnions onto the bracket. Make sure
the trunnion bolts drop through the support
bracket. Remember to position the table so
that the miter slot is to the right of the blade
as you face the front of the bandsaw.
6. Secure the table to the support bracket by
securing the two trunnion knobs (shown in
Figure 5) onto the trunnion bolts.
Figure 5. Table mounting components.
Table Trunnions
Trunnion Knobs
7. Place the round table insert in the table top
and replace the tapered pin so it fits snugly
in the hole on the side of the table. Do not
use excessive force.