Filter
Top Products
G5787 Meatcutting Bandsaw -13-
3. Fasten the motor onto the motor mount (as
shown in Figure 14) with the (4)
5
⁄16"-18 x 1"
hex bolts,
5
⁄16"-18 hex nuts and (8)
5
⁄16" wash-
ers. The washers should be placed on both
sides of the motor mount.
Figure 14. Motor to motor mount.
Figure 13. Pulley onto motor.
To install the motor:
1. Place the motor pulley on the motor as
shown in Figure 13. Notice the key on the
motor shaft. This needs to be lined up with
the keyway in the motor pulley in order to fit
the pulley on the shaft.
2. Tighten the setscrew on the pulley. You will
need to adjust it later, so do not overtighten.
Figure 15. Wiring to switch plate.
After everything is wired correctly, take off the
nuts that hold the switch to the stand. Slide the
rubber cover over the back of the switch so no
metal contacts are exposed. Push the mounting
screws through the holes on the ends of the cover
and thread the nuts back on the screws. Tighten
them securely, but not tight enough to ruin the
rubber.
Motor Wiring
Key
Before wiring, the rubber cover needs to fit over
both cords. To do this:
1. Poke a hole through the back of the rubber
cover for the cords and the ends of the cover
where the mounting screws attach the switch
to the stand.
2. Pull the motor and the power cord through
the hole in the rubber cover.
The diagram on Figure 15 shows the proper
wiring of the motor and the power cord. The
ground wires mount underneath the switch with
the 10-24 x
1
⁄2" Phillips
®
screw, nut and star wash-
er. Do not pinch the wires while installing. If they
will not reach, carefully cut back the outer layer of
the black cord. Do not cut the smaller wires
inside!