Filter
Top Products
-16- G5787 Meatcutting Bandsaw
Locate the (12) small Phillips
®
screws and attach
the tabs (raised side down) to the stand covers
as shown in Figure 24. Tighten the catch tabs
enough to give resistance so they will stay in
place, but not tight enough that you will not be
able to turn them.
Figure 24. Catch tabs in place on stand cover.
Stand Cover
The stand covers come with attached catch tabs.
Cut the catch tabs off as shown in Figure 23.
Figure 23. Remove tabs from stand covers.
The stand covers fit inside the stand openings
and attach by turning the catch tabs over the
edges of the stand.
2. Slide the fence rails into the brackets and
mount the fences on the ends with the
1
⁄4"-20
x
3
⁄4" hex bolts. The smaller rail is meant for
the side fence and the larger rail for the front
fence. The adjustment knobs fit on top of the
brackets. The finished assembly should look
like Figure 22.
Figure 21. Fence supports to table.
Figure 22. Fences installed on supports.
To install the fence:
1. Use the
1
⁄4"-20 x 1" hex bolts, nuts and wash-
ers to attach the fence brackets to the table
as shown in Figure 21.
Fence