Filter
Top Products
G9743 7" x 12" Metal-Cutting Bandsaw
-17-
Figure 8. Installing wheel.
Wheels
The wheels may be installed to make it easier to
move the G9743 bandsaw.
Components and Hardware Needed: Qty
Wheels ............................................................... 2
Wheel Brackets .................................................
2
Axles .................................................................. 2
Hex Bolts
3
⁄8-16 x
5
⁄8 .......................................... 2
Flat Washers
3
⁄8 ................................................. 2
Cotter Pins 3 x 25 ..............................................
2
Hex Bolts
5
⁄16-18 x 1
1
⁄2 ....................................... 6
Hex Nuts
5
⁄16-18 ................................................. 6
Flat Washers
5
⁄16 .............................................. 12
To install the wheels:
1. Align a wheel bracket with the frame mount-
ing holes and secure with three
5
⁄16-18 x 1
1
⁄2
hex bolts, three hex nuts, and six flat wash-
ers, as shown in
Figure 8.
2. Insert the threaded end of each axle into the
wheel bracket and secure with a
3
⁄8-16 x
5
⁄8
hex bolt and a flat washer.
3. Slide a wheel over the axle.
4. Insert a cotter pin into the axle, and spread
the pin to secure the wheel.
5. Install the opposite wheel, repeating Steps
1–4.
Chip Screen
The chip screen is designed to prevent chips and
cut-offs from entering the coolant tank.
Components and Hardware Needed: Qty
Chip Screen ........................................................
1
To install the chip screen:
1. Place the chip screen into the opening shown
in Figure 9.
Figure 9. Chip screen installed.
Wheel Bracket
Axle
Chip screen