Filter
Top Products
4.
Figure 16
Figure 16.
NOTICE
Make sure the straps do not touch the con-
trol panel pedestal in the next step. Also,
make sure they stay under the base and do
not slip to the infeed or outfeed tables to
avoid damaging the machine.
Note: Before the jointer was shipped from the
factory, the infeed table was fully raised and
the stop bolt was threaded up against the bot-
tom of it to safely secure it during transit.
To prevent damaging the table elevation
gearing, you MUST adjust the position of
the infeed stop bolt to the operating position
before attempting to lower the infeed table.
NOTICE
To prevent damage to the table elevation
gearing, NEVER force the table handwheels
if you feel resistance. Check the positions
of the stop bolts or for obstructions.
8. Figure 17
Model
Specification Comparison
Page 5
Figure 17.
5.
6.
Note: In the next step, use shims between
the base mounting points and the floor to
avoid warping or cracking the cast iron.
7.