Filter
Top Products
Infeed Table Stop
Bolt
Figure 57
Rotating /Replacing
Cutterhead Inserts
Figure 58.
Figure 58
Tools Needed Qty
To rotate or replace a spiral cutterhead
insert:
1.
2.
3.
4.
Note: Proper cleaning of the insert, Torx
screw, and the cutterhead pocket is critical to
achieving a smooth finish. Dirt or dust trapped
between the insert and cutterhead will slightly
raise the insert, and make noticeable marks
on your workpiece the next time you cut.
Tip: Use low-pressure compressed air or a
vacuum nozzle to clean out the cutterhead
pocket.
5.
6.
Note: If you use the included air pressure
torque wrench, refer to the detailed instruc-
tions on the next page for its use.
Figure 57.