Filter
Top Products
H3368 Grinder/Sander Combo -9-
Mounting
The Model H3368 weighs 27 lbs. Make sure the
workbench on which you plan to mount the
grinder is sturdy enough to hold the weight of the
machine and any downward pressure that may be
applied during operation. The workbench should
have a level surface and be heavy, or attached to
the floor, so that it will not move during operation.
To mount the grinder:
1. Find the best place in your shop to mount the
grinder/sander.
• Pick a spot on the workbench that will
allow enough room to move the size of an
anticipated workpiece around the grinder.
The operator (and possibly bystanders)
should have enough room to stand out of the
way.
• Mount the grinder in an area with proper
lighting and near electrical outlets. Lighting
should be bright enough to eliminate shadow
and prevent eye strain. Electrical circuits
should be dedicated or large enough to han-
dle amperage requirements. Keep power or
extension cords clear of high-traffic areas. If
you install new lighting, outlets, or circuits,
observe all electrical codes.
The Model H3368 can cause
personal injury if operated
by untrained users. Ensure
that your machine is inac-
cessible to children and visi-
tors by closing and locking
all entrances to your
shop/garage when you are
away.
2. Mount the grinder to the workbench with bolts
that are long enough to exceed the thickness
of your workbench and the grinder base.
Secure each bolt with flat washers, a lock
washer and a hex nut as illustrated in Figure
5. Because sizes vary for each individual sit-
uation, the hardware in this step is not includ-
ed with the Model H3368.
Figure 5. Mounting machine to the workbench.
H3368
Base
Workbench
Flat
Washer
Flat
Washer
Lock
Washer
Bolt
Nut