Filter
Top Products
H6246 Meat Cutting Bandsaw
-17-
Figure 13. Attaching table brace.
8. Thread one M6-1 hex nut halfway onto each
of the two cap screws, as shown in
Figure
14.
Figure 14. Hex nut threaded halfway onto cap
screw.
9. Insert the two cap screws into the table run-
ners so the heads are facing outward, and
tighten the remaining two hex nuts onto the
ends, as shown in
Figure 15. Note—These
cap screws act as the table stops when the
table is slid backwards.
Figure 15. Cap screws installed in table
runners.