Filter
Top Products
H6246 Meat Cutting Bandsaw
-19-
Test Run
Once assembly is complete and adjustments are
done to your satisfaction, you are ready to start
the machine.
Turn the machine
ON. Make sure that your
finger is poised on the OFF button just in case
there is a problem. The bandsaw should run
smoothly with little or no vibration or rubbing
noises. Strange or unnatural noises should be
investigated and corrected before operating the
machine further.
Run the Model H6246 for a short time to ensure
that the moving parts are working properly
with no excessive vibration. If any problems
develop, correct them before any further use the
machine.
If you cannot locate the source of unusual
noises, please contact our service department at
(570) 546-9663.
Meat Grinder
Components and Hardware Needed: Qty
Meat Grinder Assembly .....................................
1
Hex Bolt M8-1.25 x 60 .......................................
1
Hex Nut M8-1.25 ...............................................
1
Tools Needed: Qty
Wrench or Socket 13mm ...................................
2
To install the meat grinder:
1. Make sure the fork inside the meat grinder
lines up with the tang inside of the housing
that is mounted on the saw body, and slide
the meat grinder all the way onto the housing
(Figure 19).
Figure 19. Meat grinder installation.
2. Insert the hex bolt through the bolt hole
on the meat grinder assembly and fasten
securely with the hex nut.
Allways remove the meat grinder when it is
not being used. Failure to do so may result
in damage to the meat grinder, because
there is no lubrication source without meat
being processed.